Introduction

Schlenk  lines and vacuum lines provide a convenient means of manipulating air and water-sensitive materials without the use of an inert atmosphere glove box. There is no strict definition that divides the term "Schlenk line" from "vacuum line", "chemical transfer line" or "vacuum transfer line", but in some general distinctions can be drawn:
 
• Vacuum lines usually have a better vacuum (10^-4 to 10^-7 torr) than Schlenk lines (10^-2 to 10^-4torr), because vacuum lines typically have a diffusion pump. A way of delineating these would be to use the terms "Schlenk line" and "High vacuum line".

 

 
 
 

• Vacuum lines usually connect to the experimental apparatus with joints, which provide a better seal and vacuum than the simple rubber pressure tubing connections used on Schlenk lines.

 

 
 
 

• Manipulations involving the measurement or condensation of gases are usually performed on a high vacuum line. Operations involving cannulas and counterflow techniques are usually performed on Schlenk lines. The truth of this statement varies from laboratory to laboratory!

 

 
 
 

One or two manifolds?

A Schlenk or high vacuum line consists of a manifold that has several stopcocks, valves or openings in addition to a connection to a vacuum source (typically a mechanical and/or diffusion pump). Having several ports on the line is convenient because several different flasks or reaction vessels may be used simultaneously. For example, gases can be vacuum transferred from one flask to another or several reactions may be run at the same time.

 These lines may be of a dual or single manifold design. In a single manifold design, the manifold's main purpose is for vacuum. Here is an example of a single manifold design which uses all-Teflon(tm) valves and O-ring joints to ensure a good vacuum seal. Each port has its own independent bubbler, so up to three reactions can be stirring under nitrogen at one time.



 A dual manifold design provides one manifold for vacuum and another for nitrogen or a reactant gas. A connection between the two manifolds permits the nitrogen manifold to be easily evacuated.

Shown below is a diagram of a dual manifold high vacuum line. Note that the lower manifold is for vacuum and the upper one is for nitrogen.



 Two features worth noting in this drawing are:
 
 

1. Main Trap. When the line is running, this trap is immersed in a liquid nitrogen dewar. This stops volatile or corrosive vapors that have escaped the pre-trap and prevents them from entering the pump. New pumps can cost one to two thousand dollars, so protecting the pump is its ONLY role. NEVER PULL SOLVENTS INTO THE MAIN TRAP!

 

 
 
 

2. Pre-Trap. This is an additional liquid nitrogen trap to condense vapors or gases from the vacuum line. It is also used to collect solvents that are removed from reaction flasks. If you are removing a lot of solvent from a reaction the nitrogen level will drop quickly, so be sure to keep an eye on it.

 

 
 
 

This page was last updated Friday, January 11, 2002.
This document and associated figures^* are copyright 1996-2002 by Rob Toreki. Send comments, kudos and suggestions to us via email.
^*Some of these figures are adapted from the Chemglass, Inc. catalog and have been reproduced with permission.